FABRILINE BEAMLINE WEB PUNCH

1.) IS PUNCH A "C-FRAME" OR "O-FRAME"?

2.) IF PUNCH IS C-FRAME:

1.  WHAT IS THE THROAT DEPTH?(MOST ARE 22")

   

2. ARE GUIDE RODS SECURELY ATTACHED TO CARRIAGE?

3. IS THERE SLOP BETWEEN UP-DOWN GUIDE RODS AND BUSHINGS?

4. IS SET CYLINDER LEAKING OIL?

   

   SET CYLINDER IS MOUNTED ON TOP OF WEB UNIT

    
5. DOES WEB "SET" (RAISE FRAME FOR DIE TO CONTACT BOTTOM) WHEN PUNCHING HOLES CORRECTLEY?

3.) DOES PUNCH CYLINDER HAVE A ROUND END CAP SCREWED TO CYLINDER TUBE, OR SQUARE END CAP WITH TIE RODS?(LOOK AT #2-A DRAWING FOR EXAMPLE OF A SQUARE END CAP)

4.) DOES PUNCH HAVE EXTEND LIMIT SWITCH?(SWITCHES WILL BE MOUNTED ON THE SIDE OF PUNCH FRAME)

5.) DOES PUNCH HAVE RETRACT LIMIT SWITCH?(SWITCHES WILL BE MOUNTED ON THE SIDE OF PUNCH FRAME)

7.) WHAT IS THE CONDITION OF THE IN-OUT LINEAR BEARINGS AND SHAFTS? IF THEY ARE WORN OUT, THE MACHINE WILL NOT MEASURE CORRECTLY.

IN-OUT LINEAR BEARINGS

GOOD
 
FAIR
 
BAD
 

IN-OUT LINEAR GUIDE SHAFTS

GOOD
 
FAIR
 
BAD
 

8.) IS PUNCH CYLINDER LEAKING OIL?

9.) ARE THERE ANY OTHER POTENTIAL PROBLEMS? 

Fabriline Beamline Inspection list